Search results for "Fiber Bragg gratings"
showing 10 items of 13 documents
Sensitivity optimization with cladding-etched long period fiber gratings at the dispersion turning point
2016
This work presents a refractive index sensor based on a long period fiber grating (LPFG) made in a reduced cladding fiber whose low order cladding modes have the turning point at large wavelengths. The combination of these parameters results in an improved sensitivity of 8734 nm/refractive index unit (RIU) for the LP0,3 mode in the 1400-1650 wavelength range. This value is similar to that obtained with thin-film coated LPFGs, which permits to avoid the coating deposition step. The numerical simulations are in agreement with the experimental results. This work was supported in part by the Spanish Ministry of Education and Science-FEDER TEC2013-43679-R. J.L. Cruz also acknowledges financial s…
Measurement of UV-induced absorption and scattering losses in photosensitive fibers
2018
UV-assisted fabrication of gratings using photosensitive fibers is a well-established technique, based on the UV-induced permanent modification of the refractive index of the fiber material. As a result, the absorption coefficient is also changed. Here, we exploit the thermal sensitivity of whispering gallery mode resonances of the fiber itself to measure the profile of the heating along an irradiated fiber versus the input power and for different UV radiation intensities. Our technique allows discriminating between the absorption and scattering contributions to the overall losses, by comparing the results obtained with our technique with direct transmission measurements. Different photosen…
Development and analysis of a model based on chirped fiber Bragg gratings employed for cracks characterization in materials
2018
In this work a model was developed that allows to understand the behavior of a chirped fiber Bragg grating for the detection and characterization of cracks in materials. In addition to the amplitude response, we show that the group delay of the grating provides useful information for the characterization of the crack. The position of the crack can be determined thanks to the linear chirp of the grating that fixes a correlation between the spatial position and both, the wavelength and the group delay. However, our analysis shows that this simple approach has a source of error, which can be overcome if a controllable external strain can be applied to the embedded grating, additional to the st…
Tunable dual-wavelength operation of an all- fiber thulium-doped fiber laser based on tunable fiber Bragg gratings
2018
Tunable dual-wavelength emission of a Tm-doped fiber laser based on two fiber Bragg gratings (FBGs) is experimentally demonstrated. By using two FBGs with central wavelengths at 2069.30 and 2069.44 nm, stable dual-wavelength laser generation in the 2 ?m wavelength region is achieved by adjusting the differential loss of the two wavelengths in the laser cavity. Strain applied on the FBG allows independent tuning of the simultaneously generated wavelengths with separation between the laser lines in a range from 0.54 to 9 nm. The laser has output power fluctuations less than 0.093% for an output power of 77.3 mW.
Fabrication of long period fiber gratings of subnanometric bandwidth.
2017
This paper reports on the fabrication of long period fiber gratings having subnanometric bandwidth in the 1500 nm spectral region. Large gratings have been photo-inscribed in a high NA fiber, the grating pitch and the order of the HE cladding mode are optimized to produce gratings with a large number of periods and preventing the coupling to TE, TM or EH modes. Resonances with a FWHM of 0.83 nm and 0.68 nm have been achieved for gratings 15 and 20 cm long respectively, the free spectral range between transmission notches is 125 nm. The polarization effects and the sensitivity of the gratings to temperature and to strain variations are presented as well. © 2015 Optical Society of America Thi…
Tunable Dual-Wavelength Thulium-Doped Fiber Laser Based on FBGs and a Hi-Bi FOLM
2017
A tunable dual-wavelength thulium doped fiber laser is demonstrated experimentally. For the first time for the 2- $\mu \text{m}$ wavelength band we propose the independent tuning of the generated laser lines based on fiber Bragg gratings and the use of a Hi-Bi fiber optic loop mirror for the fine adjustment of the cavity losses to obtain stable dual-wavelength operation. Dual-wavelength laser generation with the laser lines separation in the range from 0.3 to 6.5 nm is obtained. The laser emission exhibits an optical signal-to-noise ratio better than 56 dB. Improved stability with output power fluctuations less than 1 dB is observed in dual-wavelength generation with equal power of lines.
High frequency microwave signal generation using dual-wavelength emission of cascaded DFB fiber lasers with wavelength spacing tunability
2010
[EN] A dual wavelength fiber laser source based on two cascaded phase-shifted fiber Bragg gratings is presented The gratings are written in an erbium-doped fiber each configuring the cavity of a distributed feedback fiber laser The spacing between lasing modes is controlled dynamically by the use of piezoelectric actuators A continuous tuning range of 5-724 pm of the wavelength difference which is equivalent to a photodetected 072-92 GHz range is obtained Efficient generation from the L to the W microwave and millimeter bands has been achieved by heterodyne photodetection of the dual-wavelength optical signal (C) 2010 Elsevier BV All rights reserved
Remote optical monitoring in remotely power assisted passive optical networks
2010
In this paper, the authors present the latest results on a simple and low cost method to achieve a dynamic and flexible network monitoring. By placing several fiber Bragg gratings (FBG) along the passive optical gigabit Ethernet infrastructure (GePON), the proposed modified optical time domain reflectometer (OTDR) is able to monitor the entire system by simply tuning its working wavelength. Furthermore, the optical network terminals (ONT), at the end users premises, have been interconnected to the trunk via an innovative cable able to both carry the optical signal as well as the power supply.
High-speed and high-resolution interrogation of FBG sensors using wavelength-to-time mapping and Gaussian filters
2019
In this work we report a novel intensity-based technique for simultaneous high-speed and high-resolution interrogation of fiber Bragg grating (FBG) sensors. The method uses a couple of intensity Gaussian filters and the dispersion-induced wavelength-to-time mapping effect. The Bragg wavelength is retrieved by means of the amplitude comparison between the two filtered grating spectrums, which are mapped into a time-domain waveform. In this way, measurement distortions arising from residual power due to the grating sidelobes are completely avoided, and the wavelength measurement range is considerably extended with respect to the previously proposed schemes. We present the mathematical backgro…
Self-referenced phase reconstruction proposal of Ghz bandwidth non-periodical optical pulses by in-fiber semi-differintegration
2011
Abstract We propose two new techniques able to retrieve the phase profile of a given temporal optical pulse based on the use of in-fiber semi-differintegral operators, where by semi-differintegration we mean either a 0.5th-order differentiation or integration. In both cases, the signal's temporal phase can be obtained by simple dividing two temporal intensity profiles, namely the intensities of the input and output pulses of a spectrally shifted semi-differintegral operator. In both cases, we obtained simple analytical expressions for the phase profile. The techniques are self-referenced and well-suited for real-time applications. We numerically prove the viability of these proposals.